A milky liquid with 100% waterproofing properties and high concentration, which becomes completely colorless after application on the surface. It is based on acrylic resins and utilizes nanotechnology, becoming completely hard and lacquer-like after drying. It is used on surfaces where more gloss and shine are desired. It is recommended to use this product as a final layer for resin and waterproofing of facades and surfaces in humid and humid climates, instead of Z90 waterproofing adhesive.
The P100 facade waterproofing resin and adhesive can withstand temperatures from -75°C to +350°C after application and is environmentally friendly. This product is fragrant and highly resistant to detergents, UV rays, and CO2, preventing the growth and penetration of moss, algae, and bacteria on the insulated surface.
100% Waterproofing
Simultaneously
For a greater visual impact on the facade
Environmentally friendly, resistant to UV sunlight and CO² gas
Anti-moss, algae, bacteria, dust, and pollution
Due to high viscosity
With a pencil and a caulking gun
Such as acrylic paints and color pigments
Resin and waterproofing simultaneously on various surfaces and facades, allowing application in humid and humid climates due to relatively high drying speed and having a hard, lacquer-like finish (non-sticky after application), creating gloss and shine on surfaces, resisting corrosion in acidic rains, and preventing layers from peeling or flaking under direct sunlight. It is compatible with various acrylic paints (water-based) and has been approved by laboratories under the supervision of the Ministry of Health for use in potable water tanks.
Clean the structure’s surface from any contamination (grease, dust, salt and efflorescence, petroleum-based materials such as oil-based paints, old coatings, etc.) and use a water jet to clean the surface.
Note: During execution, avoid creating foam and bubbles that form due to excessive brush friction on the work surface.
A: Resin and waterproofing the facade
B: Mixing with acrylic paint
For every square meter of resin and waterproofing, 100 cc
One unit of P100 resin and waterproofing sealant + four units of water (this ratio may vary depending on the surface absorption rate)
Note: Please carefully read the following points before use:
All trademarks and brands of this company are registered with the Intellectual Property Office of Iran. Therefore, any copying, imitation, or counterfeiting will be subject to legal and judicial action.
20 Liters
10 Liters
4 Liters
1 Liter
300 cc
The P100 waterproofing resin and sealant becomes completely hard and glossy after drying, making the final surface shiny. However, the Z90 sealant and resin do not alter the final surface appearance.
For every square meter, 100 cc
It is recommended not to apply it in its pure form, but to mix it in a ratio of 1 to 4 with water (4 units of water to 1 unit of P100 facade sealing resin and adhesive).
No, it cannot be applied on surfaces that have been previously painted and resin-coated.
No, one of the advantages of P100 resin and sealant is that it does not have a solvent after drying and cannot be removed from the surface. If it is spilled on a surface, it must be cleaned before it dries.
The P100 waterproofing resin and sealant is cream-colored. It is justified for use on porous surfaces, and when it penetrates the surface, it becomes completely colorless.
